SpeedoHealer INSTALLATION
2007-2008 KAWASAKI Z750 / Z1000
Note: Use this guide in conjunction with the instructions received with your SH-U01 harness kit.
1. Disconnect the 3-pole Speed Sensor connector. It is located on top of the gear box, on the left side, near the starter motor.
It has 3 wires: Blue, Pink and Brown/Black
2. Cut the Pink wire (middle lead in the connector) about 2 inches (5 cm) away from the connector, then strip off approx. 0.4" (1 cm) insulation from both wire ends.
3. Strip off approx. 0.4" (1 cm) insulation from the other two wires. Try to do this without cutting the conductor of these wires.
4. Splice the SH harness as follows (soldering is highly recommended):
| Wire color of SH harness | Wire color of Speed Sensor connector |
|
Red Black White Green |
Blue Brown with Black stripe Pink towards the connector Pink towards the main harness |
5. Use the supplied shrinkable tubes, or electrical tape to insulate the solder joints.
6. Mount the SH box under the passenger's seat with the supplied Velcro strips.
7. Route the SH harness along the frame to the location of the box, then plug-in the 4p harness connector.
8. Test the SH functions as per the the supplied install instructions.
9. Use the on-line calculator to generate the programming instructions.