SpeedoHealer INSTALLATION

2002-2008 Honda ST1300/A (non-ABS + ABS)

Note: Use this guide in conjunction with the instructions received with your SH-H01 harness kit.

1.  Remove the seat, raise and support the fuel tank.

2.  The picture below shows the location of the speed sensor coupler.

3.  Disconnect the 3p BLACK speed sensor coupler. It is in the dust boot, behind the rear of the right hand side faring. Hook up the SH harness.

4.  Route the SH harness along the frame to the location of the unit. I mounted the box near the battery holder. Plug-in the 4p harness connector.

5.  Use the on-line calculator to generate the programming instructions.

I did a check run to get the before error via a hand held GPS.

I then calibrated the speedo as per instructions for the Speedo Healer...... very easy....

another test run and compared the speedo again via the GPS..... it was spot on!! Excellent product!!

Peter P., Australia