SpeedoHealer INSTALLATION

1999-2004 Triumph Sprint RS

Note: Use this guide in conjunction with the instructions received with your SH-T01 harness kit.

1.  Remove the seat, raise and support the fuel tank.

2.  The picture below shows the location of the speed sensor coupler, on the right side of the airbox:

3.  Disconnect the 3p speed sensor coupler and hook up the SH harness connectors.

4.  Route the SH harness along the frame to the location of the unit. I mounted the box near the battery. Plug-in the 4p harness connector.
Make sure there is no sharp bend near the 4p SH connector.

5.  Use the on-line calculator to generate programming instructions.

I ended up with -7% calibration value.

Lasse I., Finland