SpeedoHealer INSTALLATION

1998-2006 Suzuki GSX600F Katana

Note: Use this guide in conjunction with the instructions received with your SH-S01 harness kit.

All work done on the left side of the bike.

1.  Remove the shown screws to gain access to the speedometer sensor plug:

2.  The black 3-pole plug below is the speed sensor coupler. Disconnect it.

3.  This is what it looks like with the SH plugs adapted-in:

4.  Route the wire harness along the frame rail. Use the two zip ties if desired.

5.  The SH unit mounts neatly in the rear tail simply held down by two-way tape:

6.  Reverse screw procedure to remount the fairing.

7.  Use the on-line calculator to generate the programming instructions.

Troy T., USA