SpeedoHealer INSTALLATION

2008- Honda GL1800/A Goldwing (non-ABS + ABS)

Note: Use this guide in conjunction with the instructions received with your SH-H01 harness kit.

1.  Remove fairing trim, remove 3 allen screws holding top and side of fairing together.
This will allow you to slip your hands in behind the fairing easier.

2.  Remove right pocket, lock assembly, lower vent register and duct.

3.  Wire bundle and speed sensor coupler is behind the air duct, see picture below.

4.  Place the SH box where you see fit, mount it with supplied velcro.

5.  Route the SH harness from the speed sensor coupler to the location of the unit.

6.  Use the on-line calculator to generate the programming instructions.

Dennis M., USA