SpeedoHealer INSTALLATION

2006-2010 Yamaha FJR1300A/AE/AS

Note: Use this guide in conjunction with the instructions received with your SH-U01 (Universal) harness kit.

1.  You'll need an SH-V4 with SH-U01 harness kit for this bike.
This bike receives the speed signal information through the ABS computer, therefore the Yamaha SH harness can not be fitted.
Splicing at the ECU is required. Note: signal calibration at this point is safe and will not interfere with ABS functions.
 

2.  Remove the seat, and locate the ECU coupler. It's a black, 44 pin connector.
For detailed steps, open the following photos:

photo 1    photo 2    photo 3    photo 4    photo 5    photo 6    photo 7

Note: some wire colors may be different on FRJ1300A variants, but the color and location of the Signal and Power are as shown.

3.  Cut the White/Yellow Signal wire (shown above) about 2 inches (5 cm) away from the connector, then use the yellow wire tap connectors supplied.

-  Splice the White SH wire to White/Yellow wire (bike harness side)

-  Splice the Green SH wire to White/Yellow wire (connector side)

4.  Locate the Red/White Power wire (see wire location above).
-  Splice the Red SH wire to Red/White wire using the red wire tap connector supplied

5.  Connect the Black SH wire to the negative terminal of the battery or chassis ground, then mount the SH box under the seat with the supplied Velcro strips:

6.  Test the SH functions as per the the supplied install instructions.

7.  Use the on-line calculator to generate the programming instructions.

John B., USA