SpeedoHealer INSTALLATION

2002-2003 Honda CBR954RR

Note: Use this guide in conjunction with the instructions received with your SH-H01 harness kit.

1.  Remove the seat, raise and support the fuel tank.

2.  The picture below shows the location of the speed sensor.

3.  Disconnect the 3p speed sensor coupler. It is in the dust boot above the speed sensor. Hook up the SH harness.

4.  Route the SH harness along the frame to the location shown below. Plug-in the 4p harness connector.

5.  Place the unit behind the side panel in the trunk.

6.  If you purchased the EXT model, mount the remote button in front of the ignition key with the supplied cable ties.
Route the cable to the location of the unit, then plug-in the 2p connector.

7.  Use the on-line calculator to generate the programming instructions.