SpeedoHealer INSTALLATION

2001-2006 HONDA CBR600F4i

Note: Use this guide in conjunction with the instructions received with your SH-H01 harness kit.

1.  SHv3.0-EXT and Honda-I harness kit unpacked:

2.  Remove the seat and left side fairing, then raise and support the fuel tank:

3.  Locate the speed sensor coupler:

4.  Close up of the coupler. It is a 3p black connector with pink, green and black wires:

5.  Disconnect the speed sensor coupler and hook up the 3p SH harness connectors.

6.  If you purchased the EXT model, mount the remote button. I zip tied it to the harness behind the left fork.

7.  Route the SH harness and remote cable along the frame to the back.

8.  Attach the SpeedoHealer box in a suitable location under the seat, with the supplied Velcro.
Plug-in the 4p harness connector and 2p remote cable connector.

9.  Use the on-line calculator to generate the programming instructions.

My calibration factor turned out to be -5.7 (with stock gearing). The Speedo now matches my GPS at all speeds.

Steve B., USA