|
The SpeedoHealer plugs in between the speed sensor and dashboard, thus
the display unit will receive the calibrated speed signal.
The SH uses 32bit arithmetic for the best possible
accuracy, and high speed real-time signal processing to ensure that the display
will be responsive at all speeds.
There is a dedicated logical unit for km/mile
conversion that works independently from the calibration unit. The selectable conversion mode takes
place after the calibration, thus enabling/disabling the conversion unit is
quickly possible any time without affecting the chosen calibration factor. This
could be useful on a trip abroad.
The unit automatically saves the top speed to internal Flash memory, which
you can recall any time to your bike's speedometer
by press of a button.
The value remains intact even if you turn off the
ignition, disconnect the battery or remove the SH from the bike.
To reset the top speed memory, just depress the SH
button for at least 2 seconds.
The programmed settings can be quickly and easily changed and reviewed, no need for special
look-up charts.
All the parameters are stored in Flash memory with
auto error detect and recovery feature,
there is no way that the settings could be unintentionally changed.
The SpeedoHealer has a special test mode to
confirm whether the installation was successful.
In addition, using the built-in 10+1 step frequency generator, the display unit of
the vehicle can be analyzed for:
- Error ratio between the speedo and
odometer
- Speedometer linearity error throughout the
whole speed range
Click HERE for the full Specifications.
|
