SpeedoHealer - Electronic Speedometer and Odometer calibrator for motorcycles

Introduction

How it works

Set Up

Ordering

SpeedoHealer

It is recommended to use our On-line Calculator, as it will calculate the optimal calibration value and will generate the programming steps as well. Click on the button to start, and follow the instructions. Alternatively, download the Calculator for off-line use.

Note to Windows XP users with SP2 installed

The Calculator uses JavaScript to function, therefore pop-up warnings in Internet Explorer will show up. This is a new 'security feature' in SP2. You should click on the Information Bar and select 'Allow Blocked Content' in order to continue. Also, it might be that some window content is not visible on the bottom, since the status bar can be no longer turned off with SP2. Simply re-size the window by grabbing the bottom right corner. If you want to get rid of these annoyances, add our site to 'Trusted sites'. To do this, go to:

Tools --> Internet Options --> Security --> Trusted sites --> Sites

Uncheck the box on the bottom, Enter: http://www.speedohealer.com , Click Add, Ok and Ok. Reload the page.

Setup basics (for more details refer to the User's Guide):

Select the required function on the Switches
Change the selected parameter's value by using the Button
Review the current value of a parameter on the LED

Assigned functions to SH Switches:

Switch no. in ON position	Selected Function	Possible values set by the button
1	Test mode on/off	Change the emitted frequency (x 2, in 10 steps)
2	Set the Conversion mode value	0: no conversion 1: mile --> km 2: km --> mile
3	Set the Sign of calibration value (+99,9 %)	0: Negative 1: Positive
4	No. of Tens in calibration value (+99,9 %)	0..9
5	No. of Ones in calibration value (+99,9 %)	0..9
6	No. of Tenths in calibration value (+99,9 %)	0..9
All	Reset	Press to confirm

The formulas for Total speedo/odo error and SH Calibration value calculation can be found in the User's Guide.